Skip navigation

Tag Archives: vice

Most vices won’t let you file a nut or saddle to shape. Their jaws are too wide and get in the way. Stew Mac make a special vice with tall narrow jaws to get around the problem. I haven’t tried it but I should think that it works fine.  However, it’s quite unnecessary. A simple pair of wooden jaws does the job perfectly well.

 

The jaws in the photographs below were intended as a prototype. I was planning to make a pair of jaws out of gauge plate or aluminium sheet and wanted to check that I’d got the size about right and that the idea was feasible. It turned out that the wooden version worked so well that I didn’t need to bother.

 

 

 

As I hope can be seen in the photographs, the device is little more than a couple of pieces of maple about 5mm thick, hinged together at their lower ends with glass fibre reinforced tape.

 

 

Most woodworking vices are designed to hold pieces of wood with sides that are parallel. This is a problem for instrument makers because much of the wood they work with is curved or tapered.

So guitar makers frequently use a carvers’ vice, which has adjustable jaws, to get around the difficulty.  Dan Erlewine uses one in his excellent series of videos, Trade Secrets.  And here’s one in my own workshop.
 

DSC_7398

 

But they’re big, heavy, ugly things (mine is a particularly repellent shade of green) and whenever possible I prefer the simpler solution of a moving accessory vice jaw. This is no more than a block of wood with one gently curved side that allows it to rotate to accommodate the work piece. The flat side is lined with cork and there’s a thin sheet of plywood is glued to the top to maintain it in position while the vice is tightened.

 

DSC_7379

DSC_7380

DSC_7381

DSC_7382

DSC_7397

 

I’ve written about these before (see here) so I’ll only say that they’re easy to make and that they’re very effective in gripping gently tapering (10° or less) objects.

 

The device below  is a little more complicated in having 2 jaws connected at the bottom with a flexible hinge made of leather. It was originally intended to hold the head of a violin or cello  bow while the mortise for the hair was being cut – an invention of Andrew Bellis, who is a bow-maker in Bournemouth.

The 2 jaws are slightly thicker at one end (hence the arrow on the top) which gives it a head start when it comes to accommodating a tapered shape. The flexibility of the hinge allows it to adapt to objects with complex curves. It’s easy to make, too.

 

DSC_7391

DSC_7393

 

DSC_7394

 

Here’s a similar idea but in a more elaborate form. I took the jaws off a small Record vice and substituted cork-lined wood. On one side there’s a permanent version of the moving jaw described earlier. A thin metal bar located by a 3mm rod keeps it in position. I’m hoping the photographs will make things clear.

 

DSC_7383

DSC_7384

DSC_7403

 

A couple of photographs of it in action. In the first it’s holding the neck of the soprano ukulele that I mentioned in a previous post. The second shows it gripping the head of a violin bow while it is being re-haired.

 

DSC_7387

DSC_7390

 

I’m pleased with how these vice jaws turned out. And it’s certainly convenient having them immediately available to hold an awkwardly shaped work piece. However, I have to say that they’re significantly more effort to make than the simple devices described earlier. Unless you’re dealing with tapers and curves a lot, it may not be worth the time and trouble.

%d bloggers like this: